Instructions for Use
4
Storing Time During Power Supply
Interruption
Do not open the freezer in case of failure or
power supply interruption! In case the
interruption is extended over longer period of
time (16 hours), take food out of the freezer
and use it, or make sure that is sufficiently
cooled (perhaps you have an extra appliance).
Disposing of the Worn Out Appliance
•
When your appliance finally wears out,
dispose it of. If the appliance has a lock,
break it, in order to prevent eventual
accidents (danger of children get locked
inside the appliance).
•
The refrigerating system of the appliance is
filled with refrigerant and insulating
substances which should be separately
treated and processed. Call your nearest
authorised service agent or specialised
servicing centre. If you don't find one, contact
your local authorities or your distributor. Be
careful not to damage the tubes on the rear
wall of the appliance (danger of pollution).
Placing and Installation
Choosing the Right Place
Place the appliance in a dry and regularly
ventilated room. Allowed ambient temperature
depends on the model (class) of the appliance
and is stated on the rating plate of the
appliance. Never place the appliance near heat
emitting devices (e.g. cooker, radiator, water
heater or similar devices) and do not expose it
to direct sunlight. The appliance should be
positioned at least 3 cm away from the electric
or gas cooker and at least 30 cm away from
the oil or coal stove. If this is not possible, use
an appropriate insulation. Behind the appliance
there should be free space at least 200 cm
2
wide and above the appliance the high kitchen
units should be at least 5 cm away from the
appliance in order to assure adequate
ventilation of the condenser unit.
Class
Ambient temparature
SN (subnormal)
from + 10°C to + 32°C
N (normal)
from + 16°C to + 32°C
ST (sub-tropical)
from + 16°C to + 38°C
T (tropical)
from + 16°C to + 43°C
Placing the Self-Standing Appliance
•
Place the appliance firmly on a solid base
and if necessary level it with the two
adjustable feet, located on the front.
•
Two spacers attached to the appliance must
be fitted onto the upper edge of the
condenser, thus preventing the appliance
from being installed too close to the wall.
Spacers are manufactured for all-purpose
function depending on the distance of the
condenser from the wall. Therefore turn
spacers correspondingly and fix them to the
appliance.
Connection to Power Supply
Connect the appliance with the cable and plug
to the power supply socket outlet with a ground
terminal (safety socket). Required nominal
voltage and frequency are indicated on the
rating plate. The connection to the mains
supply and earthing have to be made
according to current standards and regulations.
The appliance resists temporary voltage
tolerance up to -6 to +6 %.
Downloaded from Fridge-Manual.com Manuals