Installation
817-
867
520
556
660-760*
54
196
444
573
596
125-175
55
31
107
1194
700
670
720-800*
1252*
Cover door with slide function fitted, which means the cover door
slides upwards when the dishwasher is opened.
Door length
[mm]
*
It is important that you read through and follow the
instructions and directions below. Conduct installation and
connection in accordance with the separate installation
instructions.
Safety instructions
•
Connections to electricity, water and drainage must be
performed by a qualified professional.
•
Always follow applicable regulations for water, drainage
and electricity.
•
Take care during installation! Wear protective gloves!
There must always be two people!
•
Place a watertight protective tray on the floor beneath
the dishwasher to prevent damage from any water leaks.
•
Before screwing the dishwasher into place, test the
dishwasher by running the Rinse programme. Check
that the dishwasher fills with water and drains. Check
also that none of the connections leak.
WARNING!
Turn off the water supply when installing the dishwasher!
WARNING!
The plug must be disconnected or power to the socket
turned off while the work is carried out!
Setup
•
The recess and connection dimensions are included in
the separate installation instructions. Check that all
dimensions are correct before starting the installation.
Note that the height of the cover door can be adjusted
to match other fittings.
•
Make sure the area on which the dishwasher is to be
installed is firm. Adjust the adjustable feet so that the
dishwasher is level.
Drainage connection
See the separate installation instructions for necessary
information.
This dishwasher is suitable for installing in a raised recess
(to attain an ergonomic working height). This means that
the dishwasher can be placed so that the drainage hose
runs to a lower level than the bottom of the dishwasher,
such as by routing it directly to a floor drain. The dishwasher
is fitted with an integrated anti-siphon device to prevent the
machine from being emptied of water during the wash cycle.
The drainage hose can also be connected to a connection
nipple on the sink unit's water trap. The connection nipple
must have an internal diameter of at least 14 mm.
The drainage hose may be extended by a maximum of 3 m
(the total length of the drainage hose must not exceed 4.5
m). Any joins and connecting pipes must have an internal
diameter of at least 14 mm. However, the drainage hose
should ideally be replaced with a new hose without joins.
17
