Gorenje GS63160SAU, Руководство по эксплуатации

Страница: 16 / 20

Placing the dishwasher
The dishwasher is intended for freestanding installation, but
can also be installed under a worktop.
Adjust the height and slide the dishwasher
into place
24 mm
Freestanding
1
Make sure the surface on which the dishwasher is to be
installed is firm. Adjust the dishwasher's height using its
four feet so that the dishwasher is level. The dishwasher
may not lean more than 5 mm.
2
Once the feet are properly adjusted, adjust the anti-tip
feet to sit firmly against the floor.
Anti-tip feet
Built-in
1
Start by measuring the height from the floor to the bot-
tom edge of the worktop.
2
Measure the height from the floor to the top edge of the
dishwasher.
3
Adjust the dishwasher's feet by turning them clockwise
to raise or anticlockwise to lower the machine.
4
Check that there is an air gap of at least 3 mm between
the underside of the worktop and the top edge of the
dishwasher.
5
Slide the dishwasher into place.
•
Pull through the drainage and supply hoses when
the machine is slid into place.
•
Check that the hoses have no kinks or sharp bends,
and check that there is nothing that can damage the
hoses.
6
Make any final adjustments to the front feet (the dish-
washer may not lean more than 5 mm).
7
Once the feet are properly adjusted, adjust the anti-tip
feet to sit firmly against the floor.
The dishwasher can also be installed in a recess without
its worktop. See Remove dishwasher worktop.
Attach the plinth
(Packed inside the dishwasher.)
Drainage connection
min.
14 mm
16