Gorenje GS63160S, Руководство по эксплуатации

Страница: 18 / 24

350--950 mm min. 350 mm
The drainage hose may be extended by a maximum of 3 m
(the total length of the drainage hose must not exceed 4.5
m). Any joins and connecting pipes must have an internal
diameter of at least 14 mm. However, the drainage hose
should ideally be replaced with a new hose without joins.
No part of the drainage hose may be more than 950 mm
above the bottom of the dishwasher. The hose must not be
routed directly to a floor drain or the like. In such cases, the
hose can act as a siphon and empty the dishwasher.
The hose must always discharge at least 350 mm above
the bottom of the machine.
Ensure that the drainage hose has no kinks.
NOTE!
When the drainage hose is routed to a connection nipple
on the sink unit's water trap (see illustration 1), please
note that the hose must be attached at the same height
as the underside of the sink unit, otherwise dishwater from
the sink may flow back into the dishwasher. For other
connection alternatives, see illustrations 2 and 3.
1 2 3
Connection to water supply
Use only the inlet hose supplied with the dishwasher. Do
not re-use old or other spare hoses.
The supply pipe must be fitted with a water tap (stopcock).
The water tap must be easily accessible, so that the water
can be shut off if the dishwasher has to be moved.
Once the installation is complete, turn on the water tap and
allow the pressure to settle for a while. Check that all
connections are watertight.
Connection to cold water supply
Connect the dishwasher to the cold water supply if the
building is heated using oil, electricity or gas.
Connection to hot water supply
Connect the dishwasher to the hot water supply (max. 70
°C) if the building is heated using an energy-efficient means
such as district heating, solar power or geothermal power.
Choosing a hot water connection cuts dishwashing times
and reduces the dishwasher's energy consumption.
NOTE!
Do not exceed the permitted water supply temperature.
Certain materials used in some cookware cannot
withstand strong heat. See Fragile dishes in the chapter
Loading the dishwasher.
Electrical connection
Information about the electrical connection can be found on
the serial number plate. This specification must match the
electricity supply.
The dishwasher must be connected to an earthed socket.
The electric wall socket must be placed outside of the
installation area to be easily accessible after installing the
dishwasher. Do not use an extension cord!
NOTE!
Repairs and maintenance relating to safety or
performance must be carried out by a qualified
professional.
Remove dishwasher worktop
The dishwasher can be installed in a recess without its
worktop. If the dishwasher's worktop is removed, the
dishwasher must be installed so that it is enclosed on both
sides and is under a separate worktop. If the dishwasher is
installed so that one of the sides is visible, a brace must be
18