6
Installing the foam
gasket
Before inserting the appliance into the opening in the kitchen worktop, the
supplied foam gasket must be attached to the lower side of the appliance.
Do not install the appliance without the foam gasket!
The gasket should be attached to the appliance in the following way:
▪ Remove the protective film from the gasket.
▪ Then, attach the gasket to the lower side, approximately 2-3 millimetres from
the edge.
▪ The gasket must be attached along the entire length and should not overlap at
the corners.
Installation procedure
• Worktop must be placed absolutely horizontal.
• Suitably protect the edges of the cut aperture.
• Connect the cooking hob to the mains power supply (see instructions for the
connection of the cooking hob to mains power supply).
• Put the supplied springs in their places.
• Insert the hob into the cut aperture.
• Press the hob firmly towards the worktop from above.
CONNECTION TO THE POWER SUPPLY
• Connections may be carried out by a qualified technician only. The earthing
protection must comply with the standing regulations.
▪ If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
• Connection terminals are revealed when the connection box cover is removed.
• Prior any attempted connection check that the voltage indicated on the rating plate
is in line with your home power supply.
• The rating plate is located underneath the appliance.
• The appliance is manufactured for use with the power supply voltage
220-240V~.
• For the direct connection to the supply mains, it is necessary to provide device
that ensuring disconnection from the supply mains having a contact separation in
all poles that provide full disconnection under overvoltage category III conditions,
in accordance with the wiring rules.
• Such appliances are allowed to be mounted on one side next to a high kitchen
cabinet, the height of which may exceed that of the appliance. On the opposite side
however, only a kitchen cabinet of equal height as the appliance is allowed.
• Upon the completion of installation, live wires and isolated cables must be
adequately protected against accidental touching.
ATTENTION !
Before attempting any repairs on the appliance, disconnect the power supply. In
accordance with the mains voltage the appliance should be connected in line
with the attached diagram.
The earthing wire (PE) must be connected to the terminal marked with the
earthing symbol .
The connection cable must lead through the relief safety device, protecting it
from accidental pulling out. Upon the completion of installation switch all the
hotplates on for about 3 minutes to check the proper functioning.
Installation diagram
Connection must be carried out by means of harmonized cables as H05V2V2-F
(90°C), or with equal or better features.
Содержание BDF 34 X
Страница 1: ...EN Instructions for Use...
Страница 2: ...2 EN Instructions for Use 3...
