USING YOUR WI
!
FI REMOTE
POWERING ON/OFF
When the Wi-Fi Remote is OFF or in power-saving mode,
press to power ON.
Powering OFF the Wi-Fi Remote will also power OFF
the connected cameras. The Wi-Fi BacPacs will remain
powered ON so that you can quickly reconnect the Wi-Fi
Remote when you power ON again.
1. With the remote ON or in power-saving mode, press
and hold for three seconds.
2. All connected cameras will power OFF. Their Wi-Fi
BacPacs will remain powered ON.
3. The Wi-Fi Remote will then power OFF as well.
BATTERY LEVEL AND CHARGING
It is recommended that you charge your Wi-Fi Remote
for two hours before first use. You can check the Wi-Fi
Remote’s battery level on the BATTERY STATUS screen.
!
See
SELECTING REMOTE MODES
below for
instructions.
To charge the Wi-Fi Remote, connect it to a computer or
USB power supply with the included USB cable.
REMOTE LED RECORDING LIGHT
When connected to a single HD HERO2 or later camera, the
Remote LED Recording Light will flash the same patterns
as the camera.
Remote
State
Comments/Questions
Starting Up
x 3
Make duration same as
HD1, HD2
Capturing
Continuous, 1 flash/sec while capture
is occuring, as on the
HD2
. If multiple
cameras are controlled by the remote,
the LED continues to flash as long as
at least one camera is capturing. If
cameras are capturing in multimode,
the LED flash is based on the the most
continuous mode in operation; for
example, if one camera is shooting
video, the flash reflects the video
capture. The order of modes from
most continuous to least continuous
is: video, time lapse, burst, still.
Capturing
Stopped
x 3
Same as
HD1, HD2.
Error Occurs
x 5
Fast flashing (as on
HD2
). An error
can occur during capturing, this LED
pattern will disrupt the capture pattern.
Shutting
Down
x 6
Make duration same as
HD1, HD2
When the Wi-Fi Remote is connected to more than one
camera, the Remote LED Recording Light will remain lit as
long as at least one camera is capturing video or photos.
6
7
1 WiFi Remote UM ENG.indd 6-7
12/15/11 7:17 PM
