Installation
1-2
USB 4113/ basicCON 4113 – User Manual
1.2
Driver Installation
Windows Device Driver
For proper installation of the
GOEPEL electronics
USB drivers on your
system, we recommend to execute the
GUSB
driver setup.
To do that, start the
GUSB-Setup-*.exe setup program
(of the supplied CD, to be find under
USB4113-basicCON4113 \Driver,
the asterisk “*” stands for the version number) and follow the
instructions.
At present, the available device driver supports Windows
®
XP as well
as Windows
®
7/ 32 Bit and Windows
®
7/ 64 Bit systems.
The USB interface uses the
high-speed
data rate according to the
USB2.0
specification (if possible, otherwise
full-speed
).
Due to the plug-and-play ability of Windows
®
, the device will be
automatically recognized by the operating system.
On completion of the installation process, Windows
®
will request you
to reboot your computer.
For safe and reliable operation this step is strongly recommended.
After driver installation/ hardware installation, you can check by the
Device Manager
whether the devices are properly embedded by the
system.
The following figure shows the successful embedding of a
USB 4113
board or
basicCON 4113
device:
Please note that the Device Manager shows all USB controllers.
Figure 1-1:
Device Manager Display
