Guardian G2 Single Rotary Cannon
Instruction Manual
Before Getting Started
Included In Your Package
Guardian G2 Single Rotary Propane Cannon
Attached Hose and Regulator
Rotary Tripod Stand
Cover
Sounding Barrel
Tripod Stand
Follow the assembly instructions for the Guardian G2 Rotary
Tripod.
1. Install the cannon onto the rotating base arm and slide the
gas hose through the center of the base.
2. Install the blast deflector arm onto the cannon/base
connection and secure with the bolt and cotter pin
included with the tripod.
1. Assembling your Guardian G2 Propane Cannon
Important Safety Precautions
•
Read entire manual before use.
•
Never use the cannon indoors.
Carrying Handle
Pressure Regulator
1.
2.
•
Always wear ear protection while operating the cannon.
Without ear protection, temporary or permanent hearing loss
may occur.
•
The cannon should be placed on flat ground, pointing in the same direction as the wind. This will maximize sound coverage
and effectiveness, and help prevent debris from entering the barrel.
•
Do not place any objects inside the barrel, and always check that the barrel is free of debris before operating the cannon.
Never stand in front of the cannon or look into the barrel while the cannon is in use.
•
The propane tank should always be standing upright and never placed in front of the cannon barrel.
•
Keep the cannon and propane tank away from any flammable material, and keep clear of any heat sources. If you plan on
placing the cannon on top of grass, first lay a non-flammable material down to cover the grass before using the cannon.
•
If there is a fire, close the valve of the propane tank and extinguish it with a dry-chemical fire extinguisher.
Attach the Propane Tank
Install the Cannon
Secure the gas hose to the pressure regulator valve and install the pressure regulator onto the propane tank.
Upon detonation the cannon will rotate approximately 90° with each blast.
Attach one end of each chain to each side of the rotating base
with the “S” hook. Loop the other ends through the propane
tank lifting holes and back to each “S” hook. This will suspend
the tank so that it can rotate with the cannon.
