User Manual
33
EN
10.2 Explanation of the buttons
Alternatively, you can also control the air conditioner via the remote control� The buttons on the remote
control are explained below�
Symbol
Designation Description
Button ON/OFF Press the button to switch the air conditioner on or
off�
Button UP
Press the button to increase the selected value (tem-
perature, timer)�
Button DOWN Press the button to decrease the selected value
(temperature, timer)�
Button TIMER Press the key to set the timer function�
Button MODE Press the button to set the operating mode�
Button SPEED Press the button to set the fan level�
Button SLEEP Press the button to activate or deactivate the SLEEP
mode�
10.3 Changing the battery
If necessary, replace the empty battery with a new one of the same type (See chapter 2�4)
1� Open the battery compartment (12) by pushing the small lever to the side and then pulling out the
battery compartment�
2� Remove the empty battery�
3� Place the new battery in the battery compartment with the positive pole facing upwards�
4� Close the battery compartment again�
5� Dispose of the empty battery properly�
See also chapter 15.2.
11 Operation
11.1 Operating modes
The air conditioner can be used in four operating modes� The operating modes
ventilation
,
dehumidifi-
cation
,
cooling
and
automatic
are available�
The air conditioner has an internal memory� The temperature and fan speed settings in the operating
modes are retained when you switch the air conditioner off and on again�
Ventilation
In
ventilation
mode, the room air is circulated� You can set the fan speed�
No cooling or dehumidification takes place. In this operating mode, the room temperature is not affec
-
ted�
Dehumidification
In
dehumidification
mode, the relative humidity is reduced� The air conditioner automatically runs
through different cycles� In this operating mode, air should not be able to escape from the room (e�g�
through an open window)�
The low fan speed is active and cannot be changed� In this operating mode, the room temperature is
not affected�
Cooling
In the
cooling
operating mode, heat is extracted from the room air and the cooled air is fed back into
the room� Part of the air, the extracted heat and any condensate are discharged outside via the exhaust
hose. In this operating mode, air should be able to flow in from an adjacent room, for example through
a door gap�
The fan speed and the desired room temperature can be set� In addition, the SLEEP mode can be ac-
tivated�
