PANEL DESCRIPTIONS
Rear Panel
1. Mini-USB:
For technical support only [firmware update]
2. Signal LED:
Signal LED indicator
3. HDMI IN:
Connect to a HDMI input source
4. EDID Management Rotary control:
MODE 0
EDID Full-HD(1080p@60) - 24bit 2D video & 7.1ch audio
MODE 1
EDID Full-HD(1080p@60) - 24bit 2D video & 2ch audio
MODE 2
EDID Ultra-HD(4K2K@30) - 24bit 2D video & 7.1ch audio
MODE 3
EDID Ultra-HD(4K2K@30) - 24bit 2D video & 2ch audio
MODE 4
EDID Full-HD(1080p@60) - 36bit 2D video & 2ch audio
MODE 5
EDID HD(1080p@30)(1080i@60)(720p@60) - 24bit 2D video & 2ch audio
MODE 6
Auto EDID analysis
MODE 7
EDID learning
5. HDMI OUT:
Connect to a HDMI display with a HDMI male-male cable here
6. Link RX LED:
Link indicator
7. HDMI Signal OUT1-3:
Link to each HDMI display via a Cat-5/5e/6 cable with a HDMI over Cat.X
receiver.
8. IR Receiver:
Infrared 3.5mm socket for plugging in the extension cable of IR receiver
9. IR Blaster:
Infrared 3.5mm socket for plugging in the extension cable of IR blaster
10. RS-232:
Firmware update and software control
11. Dip Switch:
Switch between normal operation mode (ByPass) or firmware update mode(switch ON)
12. Power LED:
Power indicator
13. +5V DC:
Connect to the +5VDC 4A power supply unit
3