GÖLZ Bridge Saw, Оригинальное руководство по эксплуатации, Страница: 42 / 86

10 Faults
42 / 86
10.3 Fault table
Error message / fault Possible cause Removal Personnel
Machine without function
when switched on Power plug not properly
secured Check proper connection to
the power supply Operating personnel
Power plug defective Check mains plug for
function, replace if
necessary Qualified electrical
personnel
Loose connection in the
electrical system Have the entire electrical
system of the machine
checked by
Drive motor defective Have drive motor checked,
replace if necessary
Main switch defective Have the main switch
checked and replaced if
necessary.
Machine does not have
sufficient power Power plug too long,
cable drum in rolled up
condition Observe the prescribed
length of the mains plug.
Unwinding the cable drum Operating personnel
Power of the local grid is
not sufficient Observe and adhere to the
connection data of the
machine
Drive motor no longer
holds speed Have drive motor checked,
replace if necessary Qualified electrical
personnel
Little or no cooling water
flow The water pump sucks
air Fill up with water; swing the
water pump with the
suction side down Operating personnel
Hoses clogged Clean hoses
Hose kinked Check the routing of the
hoses
Hose leaking or
detached Replace hose or fasten
correctly
Pump wheel of water
pump dirty (strainer) Clean pump wheel or
strainer
Water pump without
function Have the electrical supply
line to the water pump
checked, replace if
necessary Qualified electrical
personnel
Motor does not run Power plug not
connected correctly. Check mains plug for
correct connection Operating personnel
Fuse on the site
distribution board has
triggered Check fuses
Saw blade wobbles Blade tension is poor Send in saw blade Manufacturer
Segments come loose Overheated, insufficient
cooling Check cooling water supply Operating personnel
Resolder segments Manufacturer