GÖLZ Bridge Saw, Оригинальное руководство по эксплуатации, Страница: 34 / 86

8 Operating
34 / 86
8.5 Cutting process
8.5.1
Normal cuts with 90° adjustment
When used in 90° position, the cutting head is in the fixed position. Proceed as follows for
adjustment:
1. switch off the machine -> the cutting disc must not turn!
2. loosen the adjusting screw
3. place the cutting head in the desired position
4. tighten the adjusting screw -> check that the cutting head is fixed in height and cannot move
5. place the material to be cut on the table
6. check the position of the material using the angular stop.
7. start the engine and the water pump and open the water tap
8. Grasp the chain-guided crank handle on the cutting head with your right hand and the
transport handle on the machine frame with your left hand
9. Then crank the cutting head slowly and without pressure through the loaded material. The
cutting disc will then cut through the material
NOTE!
The cutting disc must not touch the table, regardless of its position or the position of the cutting
head!
NOTE!
In an emergency, use your left hand to operate the emergency stop button on the switch.