20
ATTACH GUIDE POLE MOUNTING
BRACKET(S)
Note: The Guide Pole Mounting Bracket referenced in this step
are optional parts purchased with the Tornado Boat Lift. If the
Guide Pole Mounting Bracket part was not ordered and included,
you may skip this and the following step.
1.
Insert the Guide Pole Mounting Bracket into the bottom of
the Bunk support as depicted in Figure 20.
2.
Align holes in Bunk support and Guide Pole Mounting
Bracket, making sure the lower guide adjustment tube is
angled upward toward the outside of the lift, and downward
toward the inside of the lift as shown in Figure 21.
3.
Attach one (1) 3/8” Flat Washer over two (2) Hex Bolts and
insert into the corresponding holes in the Bunk support as
depicted in Figure 20.
4.
Attach one (1) Lock Washer and one (1) Hex Nut to each of
the protruding Hex bolts and fasten with appropriate
wrench until secure.
5.
Repeat this step three (3) more times, once for the opposite
end of the Bunk, and twice for the second Bunk.
PARTS REQUIRED TO INSTALL GUIDE POLE
MOUNTING BRACKET
Guide Pole Mounting Bracket (4)
3/8” Hex Nut (8)
3/8” Lock Washer (8)
3/8” x 5” Hex Bolt (8)
Figure 20
Figure 21
3/4" Flat Washer (16)
