17
door, the installer needs to install a motor to the driver’s door first. Please connect the wires as
figure 4.
3. if the car has been installed with the central lock system, the installer can select pneumatic lock
through the jumper inside the main unit, please connect the wires as figure 5.
▶ ▷
Installation Notice
a. For the car security and service functions most efficiently, we recommend that you trust with professionals to
install the system in your car.
b. To avoid to damage the SIM card, please install the SIM card into the main unit after cut off main unit power
and take away the inside battery.
c. GPS antenna should be placed flat and main face should be up, the leaning angle can’t be more than 45
°
.
d. Please install the system in a hidden place to protect it from invalid un-installation; and also keep in in a dry
place to avoid damage from the wet.
e. Don’t put the system near the engine, as the high temperature will make the system work abnormally and
shorten its life.
f.
After installation, please pack the connected wires well, and must keep it insulating from the car body to
avoid accident caused by short circuit.
▶ ▷
Installation Steps
a. Before installation, please prepare an ordinary mobile phone SIM card with GPRS available. This SIM card
will be phone number of the system. To ensure the system work successfully, please make sure that the
telephone charge of the SIM card is enough.
b. Please install the product according to the Wire Diagram in a hidden place. (P18)
c. After all the wires connected well, please disconnect the main power and take away the back up battery. Put
the prepared SIM card into the SIM card socket, and then connect the main power and put the back up
battery into the main unit.
d. 60 sec after installation and being power on, please use the phone to call the SIM card inside the system to
make sure whether the system can connect to the GSM network or not.
e. If “System is connected, ready for setting” is heard, it means that the GSM network works and the main
bound phone set succeeds; if no answer, or can’t get through with the SIM card, it means that the system
cannot connected to the GSM network and has no main bound phone set. Please disarm the system by
transmitter and take away the back up battery and cut off the main power, check whether the GSM antenna
is attached well, or whether the SIM card inside the product is placed well. After checking everything well,
repeat step d.
f.
If user’s phone is connected with the system well and set as the 1
st
supervisor phone, it means that the
installation is successful.
