Golden Dragon XML6125CLE, Руководство по ремонту

Страница: 80 / 613

德纳（北京）电机有限公司 Dana (Beijing) Electric Motor Co. Ltd
. 电话 Tel ： 010 － 69596333
北京市通州区宋庄 Songzhuang Tongzhou District Beijing 101118
德纳（北京）电机有限公司
Dana (Beijing) Electric Motor Co., Ltd.
Note : The lower baffles must be installed first before installing the upper baffle, so that the upper baffle presses the
lower baffle at the joint.
2.Tools for use
Fixed value torque wrench 10-50Nm, ratchet wrench, No. 13 sleeve,
3. List of maintenance parts:
No. Part number Name of part Quantity per unit Part replacement standard
1 Plate-15 upper baffle 1 Severe deformation and damage;
2 Plate-16 lower baffle 1 Severe deformation and damage;
3 HW-1742 Hex flange bolts 4 Thread damage and corrosion;
9.1.3.2. Operation specifications for lifting bracket and nameplate replacement:
1. Steps: see the diagram (Figure 3)
Step 1: Use a ratchet wrench and sleeve to remove the lifting bracket.
Step 2: Install the new lifting bracket on the motor middle cover. The
screw tightening torque is16 ± 2Nm
2.Tools for use:
Fixed value torque wrench 0-10Nm, outer hexagon wrench, ratchet wrench, No. 13 sleeve
, Figure (3)
3. List of maintenance parts:
No.
Part number of
maintenance part
Name of maintenance
part
Quantit
y per
unit
Maintenance part replacement
standard
5 3316-0519 Lifting bracket 2 Breakage and deformation
6 BNAEB074 Hex flange bolts 4 Thread damage and corrosion;
9.1.3.3. Operation specifications for nameplates and related parts replacement:
1. Steps: see the diagram (Figure 4)
Step 1: Use needle-nose pliers to remove the rivet, and then remove the
nameplate (if the nameplate is directly attached to the motor with 3M glue,
it can be removed with a flat screwdriver).
Step 2: Install the new nameplate on the middle cover of the motor and use
a hammer to knock four new rivets into the holes.
2.Tools for use: (Figure 4)
Hammer, flat screwdriver, needle-nose pliers
2-54