Golden Dragon XML6125CLE, Руководство по ремонту

Страница: 116 / 613

德纳（北京）电机有限公司 Dana (Beijing) Electric Motor Co. Ltd
. 电话 Tel ： 010 － 69596333
北京市通州区宋庄 Songzhuang Tongzhou District Beijing 101118
德纳（北京）电机有限公司
Dana (Beijing) Electric Motor Co., Ltd.
11.5. High-voltage power line (DC bus) maintenance items
No.
Maintenance
content
Technical requirements Tool Operation specification
Maintenance
interval
1 Appearance
The wiring harness is
complete, and the outer
insulation layer is free of
signs of cracking, damage,
cracking, aging, etc.
Visual inspection
Visually inspect the wiring harness for
intactness, signs of skin peeling,
damage, cracking, etc., especially pay
attention to check the turn and the line
crossing
Every 5,000
KM
The air around the wiring
harness circulates and is
easy to dissipate heat.
There should be no spikes /
sharp objects, dry, dust-free
Visual
inspection, brush
and vacuum
cleaner Visually inspect and clean the surface
with a brush or vacuum cleaner to
remove surface ash, impurities and
foreign matter
Every 5,000
KM
2 Installation
The bending radius of the
wire harness must be 8
times or more the diameter
(about 110mm)
Visual inspection
and tape measure
Visual inspection and actual tape
measure to check if the bending radius
of the wire harness is 8 times or more
the diameter
Every 5,000
KM
The wiring harness should
be tied firmly and not
loose. Vehicle wiring and
fastening must meet the
design requirements of the
vehicle manufacturer
Visual inspection
and touching
with hands
Visually and manually check the
binding of the wiring harness. For
example, check whether the bandage is
lost, the fixing clips are loose, the
fixing glue is detached, and the thread
protective cover is missing
Every 5,000
KM
The wiring harness cannot
be bundled with low-
voltage wiring harness,
gas, oil, water, etc.
Visual inspection
Visually check whether the wiring
harness is bundled with low-voltage
wiring harness, gas, oil, water, etc.,
unless effective isolation measures are
ensured
Every 5,000
KM
Harness lugs are not loose
and secure
Torque wrench
and sleeve/
hexagonal
combination kit
Cooperate with corresponding tools,
review and tighten according to the
established torque requirements
Every 2,000
KM
The harness lock is not
loose and fastened
securely. Torque of lock
base: 15Nm; Torque of
lock cover: 12Nm
Lapp
—61610000
—61610013 Cooperate with corresponding tools,
review and tighten according to the
established torque requirements
Every 2,000
KM
Harness cover / cover is
not loose and fastened
Torque wrench
and sleeve/
hexagonal
combination kit
Cooperate with corresponding tools,
review and tighten according to the
established torque requirements
Every 2,000
KM
2-90