CAN-bus Cruisecontrol GC90Ci installation manual
8
3.3
T-harness connection
Undo the negative battery terminal before working on the vehicle.
Loss of volatile data is possible (audio, board computer, clock, etc.)
As the T-harness is model specific, it is supplied as a separate component.
Read the accompanying installation manual carefully.
Connect the T-harness as follows:
Connect the 8-pin black connector of the T-harness to the 8-pin connector on the
EM;
Undo the accelerator pedal connector and connect it to the T-harness;
Connect the T-harness connector to the accelerator pedal.
3.4
Wiring harness connections
Always use a multimeter when measuring on the vehicle
Cut wires to size, keep them as short as possible
CAN-wires are twisted to assure a reliable operation. Make sure that the
twisting remains the same when the CAN-wires are shortened or extended
As the GC90Ci is supplied model specific. Connect the wiring harness as instructed in the
supplied specific installation manual.
Connect the universal wiring harness as follows:
orange wire
connect to an ignition switched feed (+15), preferably directly after
the ignition switch
blue wire
(twisted pair)
connect to CAN high
blue/white
wire
(twisted pair)
connect to CAN low
8-pin connector
Connect to the 8-pin connector of the CM, also refer to the
installation manual CM
4-pin connector
do not use
