Top Half
Antique Unifloss
Model Series: 3119
Page 6
gmpopcorn.com
Setup
This unit has been tested at the factory.
1.
Remove all packaging and tape prior to operation.
2.
Place the unit on a sturdy, level base, or cart. For Countertop installation, place the
unit over a cutout in the countertop. A shelf (sold separately) is required under the
counter to set the floss unit on.
3.
Blower vents out the top of unit, allow adequate clearance for airflow.
4.
To Install the Display Lights (if equipped, select Models only):
There are 15
Display Lights on the unit. Each light has a bulb, clear lens body, and a clear lens cap
(the lens body and lens cap snap together for use as a light cover assembly), unpack
the display light parts, and assemble as shown below.
Carefully screw a bulb into each socket, be sure the bulb is started in straight so it goes
in correctly, then press an assembled light cover over each bulb (the light cover snaps
into the socket ring on the popper).
Note
–
To Change a Display Light Bulb:
Turn machine OFF, unplug unit and allow it
to cool before attempting to remove a light cover assembly. Carefully pull the
light cover assembly straight out of the locking ring,
DO NOT
pry down to
remove cover, or the bulb may break.
5.
After setup, unit should be cleaned prior to use (see Care and Cleaning section).
Clear Lens Cap
Socket Ring
Display Light Bulb -
Carefully
install each bulb (ensure bulb
goes in socket straight).
Clear Lens Body
Light Cover Assembly
(Snap the Lens Body and Lens Cap
together; install and remove light
cover as an assembly).
Display Light Installation
(Model 3119 shown)
(Model 3119NL not equipped with Display Lights).
