Instruction Manual - Touch Screen
2011, 2848, 2860, 2872, and 2873 (32 oz. Pop-O-Golds)
PopClean Elite Popper -600 Series
2911, 2948, 2960, 2972, and 2973 (52 oz. Medallions)
Page 62
gmpopcorn.com
Agitator Set Collar Adjustment
The following instructions describe how to properly adjust the set collars on a 32 or 52 oz. kettle
agitator assembly.
Steps to Adjust Set Collars on a 32 or 52 oz. Agitator Assembly
Agitator assembly is adjusted while fastened to the kettle (image shown for general reference only).
Step 1.
Turn machine OFF, unplug unit, and allow it to cool completely before attempting to
adjust the agitator height.
Step 2.
Loosen the set screw in the set collar above the crossbar and below the crossbar.
Step 3.
Place a 1/32”
(1 mm) gauge (thickness of a dime) under the base of the agitator shaft to
adjust clearance between the kettle cook surface and the shaft; reference image shown. Once
adjusted, re-tighten the set screw in the set collar
above
the crossbar to secure shaft in place.
Step 4.
Adjust clearance between the
bottom of the crossbar and the
lower
set coll
ar to 1/32”
(1 mm) (thickness
of a dime); reference image shown.
Once adjusted, re-tighten set screw to
secure in place.
Step 5.
To check for proper
adjustment, make sure the stir rod is
parallel to the kettle cook surface (it
should be close - but not touching).
Step 6.
Spin the agitator shaft by
hand to ensure it spins freely and
is not dragging the bottom of the
kettle.
Step 3:
Adjust clearance to
1/32” (1 mm)
(thickness of a dime)
Kettle Cook
Surface
52 oz. Agitator shown for
general image reference only
(lids not shown for clarity).
Set Collar w/Set Screw
above Crossbar
Lower Set Collar
Agitator Shaft
Step 4:
Adjust clearance to
1/32” (1 mm)
(thickness of a dime)
Crossbar
*Stir Rod
(52 oz. SINGLE
Stir Rod shown - rod is
welded to shaft)
*NOTE:
EXPORT MODELS
have 2 stir rods installed on
the agitator hub, with the
option to have 4 stir rods.
(Order PN 100390 for each
additional Stir Rod needed).