PURELL
®
/ GOJO
®
Smart Dispenser
Installation Instructions
Install. Activate. Simplify.
Step 1
Install your PURELL or GOJO Smart Dispenser
* visit http://www.dispenserhelp.com/ for video instruction
6”
15.24 cm
When installing above a countertop, be sure
at least 6” clearance is provided.
Open dispenser by pushing on one of
the dual side latches until it releases.
Clean installation surface with an
alcohol pad. Allow surface to dry
for 60 seconds. Peel paper off
installation tape.
seconds.
For maximum adhesion,
Tape Installation
Using back plate as a template, press a
pencil through the installation tape to
mark the holes. Drill holes. Install with #10
x 1 anchors and Type A #10 x 1 screws.
Screw Installation
IMPORTANT:
You must complete steps 2 & 3 (located on back page) before using your dispenser.
The dispenser will remain in set-up mode (blue blinking status light) for 4 hours.
Reference the FAQ section of the App for dispenser reset instructions.
Close dispenser. Status light will blink blue to
indicate there is power to the dispenser and
to indicate the dispenser is in set-up mode.
To activate battery pack, remove pull tab as
indicated by red arrow.
featuring
See Reverse Side for Continued Instructions
