GF-LGT MANUAL
2012
1
Virtual Pilot Operating Handbook
GF-LGT
Landing Gear and Trim Control
Cockpit Control Module
Congratulations on your purchase of the
GoFlight
GF-LGT II Landing Gear and
Trim Control Module
, part of the
extensive family of GoFlight Cockpit
Control System modules.
The GF-LGT II is designed to operate
with a wide variety of simulated aircraft,
and is sure to make your simulated flying
more realistic and enjoyable.
To get you up in the
“virtual skies” as
quickly as possible, the following steps will assist in ensuring the GF-LGTII will be easy to install and
configure.
Installing the GF-LGT II Module
NOTE:
If you own other GoFlight hardware and have already installed the most current version of
software on your system, you do not need to install the software again. Simply skip the software
installation steps in the instructions below
.
. On the home page click on
Support/Downloads.
2. Click on
Software
.
3. Click
“Run” or “Save” and follow the instruction to install the software.
If the software installer detects that GoFlight software is already installed on your system, it will prompt
you to overwrite. Click the
Yes
button to overwrite the existing version of GoFlight software. This is
useful if you wish to keep the configuration settings for other GoFlight modules installed on your system.
However, you should first make sure that the software you are overwriting is an older version and not a
newer one.
4. If you are going to mount the GF-LGT II module into a GF-AC rack, install the module in any desired
location in the rack using the two thumbscrews provided.
