Goepel PCI 61 Series, Оригинальное руководство пользователя

Страница: 53 / 56

Software
PXI/ PCI 61xx – User Manual 4-19
4.5 Additional Software Interfaces
The Software Interface “FS1” (File System) allows, amongst others,
creating, copying, deleting, executing and searching of files on the
hardware.
Thus, it allows uniform access to the OnBoard File System.
The Software Interface “Net2Run” (Net2Run1..Net2Run4) serves for
the creation, configuration and execution of Residual bus simulation.
Several bus interfaces for CAN, LIN and FlexRay networks can be
simulated simultaneously and continously.
The “Net2Run” interface supports loading and executing of so-called
Residual bus simulation files (*.rbs). These are preconfigured
command sequences containing a static Residual bus simulation.
The corresponding files are created by means of the “Net2Run”
Configurator Tool.
“Net2Run” is subdivided into several Software modules, strongly
leaning to “AUTOSAR”.
The following Software modules do exist:
♦
COM
♦
PDU-Router
♦
CAN-Interface
♦
LIN-Interface
♦
FlexRay-Interface
♦
PDU-Multiplexer
♦
CAN-NM
♦
FlexRay-NM
Hence, the routing of PDUs of e.g. CAN1 to CAN2, CAN1 to LIN3 or
FlexRay2 to CAN4 is possible (PDU-Gateway). The routing of individual
signals can be realized by a COM-Signal-Gateway. In order that
several independent Residual bus simulations can be executed on one
card (e.g. one Residual bus simulation on CAN1, CAN2, CAN3 and
CAN4 each), several “Net2Run” Interfaces do exist (4).
The Software Interface “Sequence1” allows recording and playing of
Firmware commands as a command sequence, short “Sequence”. A
Sequence can also permanently stored under an arbitrary name on
the board.
By using its name, this Sequence can be loaded again and played.
The automatic loading of a Sequence after switching on the board e.g.
allows the automatic configuration and starting of a Residual bus
simulation (in the case the required commands are included in the
Sequence).
4.5.1 FS
4.5.2 Net2Run
4.5.3 Sequence