Goepel PCI 61 Series, Оригинальное руководство пользователя

Страница: 13 / 56

Hardware
PXI/ PCI 61xx – User Manual 3-1
3 Hardware
3.1 Definition
PXI/ PCI 61xx ( Series 61 ) controllers from GOEPEL electronic GmbH are
programmable intelligent multibus controllers providing various
communication interfaces for vehicle network testing and general
control applications.
The
Series 61 controller can generally provide the following features:
♦
Basic versions of the communication interfaces:
PXI/ PCI 6153 – 2 CAN interfaces onboard
PXI/ PCI 6173 – 2 LIN or KLine interfaces onboard
PXI/ PCI 6181
– 1 CAN and 1 LIN or KLine interface onboard
PXI/ PCI 6191 – 2 FlexRay nodes with 2 channels each
(see OnBoard Interfaces and FlexRay Extension Board )
♦
optionally 2 further (in case of PXI/ PCI 6191 4 further)
CAN/ LIN/ KLine interfaces onboard
(see OnBoard Interfaces )
♦
optionally 2 FlexRay nodes with 2 channels each
on FlexRay Extension boards (not for PXI/ PCI 6191 )
(see FlexRay Extension Board )
♦
optionally instead of the second FlexRay Extension board
1 CAN Extension Board with 2 CAN interfaces
(see CAN Extension Board )
♦
4 digital inputs, 4 digital outputs with TTL level onboard
♦
optionally 4 additional digital inputs/ outputs
with extended voltage level
(see IO Extension Board )
♦
optionally 4 or 6 additional analog inputs/ outputs
(see IO Extension Board )
♦
optionally up to 2 SENT outputs
according to SAE J2716 (Jan. 2010) for Sensor simulation
(see SENT Interfaces )
♦
600MHz Power PC with 512MB RAM, 256MB Flash
♦
Galvanic isolation between communication interfaces/ IO
channels and user interface
♦
High flexibility through pluggable transceiver modules
and Extension Boards
♦
Control of the devices via PXI/ PCI or Ethernet
(see Addressing and Ethernet )
♦
The 1 Gbit Ethernet interface at the Front panel
is also useable as volume data and debug interface
♦
Visualization of the operating states by four LEDs
arranged at the front panel (see Status LEDs )
Instead of 2..4 CAN Interfaces, a
PXI/ PCI 6153
board can also have
2..4 CAN-FD Interfaces onboard. Currently, the options LIN/ K-Line
as well as CAN5 / 6 (CAN Extension board) are not possible in this
case (see also Firmware Variants ).