Robo H2O Pool
TM
Cleaner Quick Start Guide
IMPORTANT SAFETY INSTRUCTIONS
Read all instructions before using this pool cleaner.
DROWNING AND SUCTION RISKS!
In order to effectively clean your pool, this
ROBO H20
cleaner operates through the use of suction. You must be aware
of serious risks created by the misuse of this suctioning cleaner. If you do not follow the instructions and warnings set out
below, serious bodily injury and/or entrapment and drowning may occur:
•
Do not allow swimmers to enter pool when cleaner is in use. No exceptions!
•
This pool cleaner should be used only by adults
who can properly operate the pool cleaner. Children should never
be allowed to use, or play near, the cleaner or hose.
•
Instruct swimmers of the dangers
of contact with suction ports, cleaner head and cleaner hose as disclosed in these
instructions.
•
Do not allow anyone to apply the cleaner or its suction hose to hair, clothing, or body parts.
Keep hair, fingers,
loose clothing, and all body parts away from the cleaner, its hose and suction parts. The pool cleaner and/or its hose
could get ahold of your hair, clothing or body parts and cause serious bodily harm or injury. Suction from the pool
cleaner or the hose could also trap a pool user under water.
•
You must cover the suction port in the pool wall
when the port is not being used for the cleaner. Failure to cover the
port can lead to entrapment injury and/or drowning.
SAFE USE OF YOUR POOL CLEANER
STOP PUMP PRIOR TO USING THE POOL IF CLEANER IS INSTALLED
If cleaner is in the pool, you must stop the pump before any swimmers enter the pool. If cleaner is operating in the pool
while bathers are present, the cleaner as well as its hose and suctions ports could entrap swimmers and cause perma-
nent injury or death.
STOP PUMP TO SERVICE CLEANER
Turn off the pool pump and all suction prior to inspecting or performing maintenance on the cleaner. Moving parts inside
the cleaner head as well as suction from the pool system can cause harm to fingers or other body parts.
STOP PUMP TO MOVE CLEANER
Turn off the pool pump and all suction prior to removing the hose. Move the hose and pool cleaner to an area of the pool
that is not in use. If there is potential for the hose to interfere with pool users, remove it from the pool.
USE CLEANER ONLY AS DESCRIBED IN THIS MANUAL
Use only with Goby recommended attachments, replacement parts and accessories.
PREPARING YOUR POOL
Before installing your
Robo H2O Pool Cleaner,
you need to prepare your pool as
Robo H2O
will not operate unless the
filter system is clean and ready for use. Backwash or manually clean filter prior to installing
Robo H20.
This cleaner was not
designed to be the first clean after pool construction or at the beginning of the season. If you have a vinyl pool, check for
wear and tear, creases in the vinyl, or any obstructions under the liner. Gunite, plaster, tile and fiberglass pools must be in
good condition. Pool must be cleaned of algae and debris prior to the cleaner’s first use.
CHECK CONTENTS AFTER PREPARING YOUR POOL
Remove the
Robo H2O
cleaner and all accessories from the box to check the contents.
Refer to Figure 1.
Note:
It is important to hold the cleaner by the handles and not to hold it in any other location.
NO
:
Description
Part #
Quant
1
Robo H2O Pool Cleaner Head
65001
1
2
Hose Lengths
65226
12
3
Flow Control Valve
65231
1
4
Female/Female Hose
(for skimmer installation only)
65227
1
5
Hose Float
65229
1
6
Control Valve Adaptor
61231
1
7
Flow Gauge
65232
1
Figure 1
