18
TROUBLESHOOTING TIPS
1.
PROBLEM: The foam sleeves on my
armrests
or
push handles
slip off of the aluminum tubing.
SOLUTION: Wrap the aluminum tube in two or three
locations along the aluminum tube with some electrical
or duct tape in order to provide additional friction.
2.
PROBLEM: The
seat assembly
becomes detached
from the
rolling frame
and needs to be remounted.
SOLUTION: Lay the
rolling frame
on its side and slide
the
seat assembly
on to its nylon rollers located on the
underside of the
rolling frame
. The retractable spring
lock located on the front of the
seat assembly
should
automatically lock when the seat is slid into the proper
position with the lock in “auto-lock” position [See #6
under “Operating Instructions”, above].
3.
PROBLEM: I am concerned that the adjustable non-
skid swivel glides located at the bottom of each of the
four legs on the
tub section
might slide or that they
could scratch or damage the surface of the bathtub.
SOLUTION: Place a rubber bath mat on the floor of
the tub before placing the
tub section
down.
