GMV GreenLift 3010 2CH A3, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 28

D
ISTRIBUTOR
3010
I
NSTALLATION
, U
SE AND
M
AINTENANCE
ENG
15 / 28
10991838 EN - 0.02 - 04.02.2021
3.2.3 ADJUSTMENT OF THE LEVELLING SPEED (LOW SPEED)
For a correct and safe adjustment of the levelling speed (low
speed), refer to the following procedure:
1. Loose the counter nut of the levelling speed adjustment
screw (2).
2. Tighten the screw (2 CW) to reduce the levelling speed
(D-E upward, H-I downward), loose to increase it
(CCW).
3. Adjusted the speed, tighten the counter nut of the screw
(2)
4. The levelling speed (low speed) adjustment is done.
NOTE
The levelling speed must be 1/6 - 1/8 of the upward
speed (high speed) and in any case the car must
complete the travel at low speed without oscillating
or tearing
NOTE
At the end of the levelling speed adjustment (low
speed) proceed immediately with the upward speed
adjustment (high speed).
3.2.4 ADJUSTMENT OF THE UPWARD SPEED (HIGH SPEED)
For a correct and safe adjustment of the upward speed (high
speed) refer to the following procedure:
1. Move the lift to the upper floor
2. Loose and remove the protection cap of the high speed
adjustment screw (8).
3. Loose the counter-nut of the screw (8). Tighten the
screw (8 CW) until you heard that the fluid drains into
the tank.
4. When the noise of the fluid is heard, loose the screw (8)
by 1 turn to stop the fluid discharge into the tank.
5. Tighten the counter-nut of the screw (8).
6. Put back and screw the protection cap of the screw (8).
7. The upward speed (high speed) adjustment is done.
3.2.5 ADJUSTMENT OF THE DOWNWARD SPEED (HIGH SPEED)
NOTE
The downward speed can be increased in comparison to the upward speed (up to max 20% more).
For a correct and safe adjustment of the downward speed
(high speed) refer to the following procedure:
1. Loose and remove the protection cap of the downward
speed adjustment screw (9 CW).
2. Loose the counter-nut of the screw (9 CCW).
3. Tighten the screw (9) to increase the downward speed.
Loose it to reduce.
4. Adjusted the speed, tighten the counter nut of the screw
(9).
5. Put back and screw the protection cap of the screw (9).
6. The downward speed (high speed) adjustment is done.