GMS B36, Руководство по эксплуатации и техническому обслуживанию, Страница: 6 / 29

B36
5
1 Machine Frame 5
Zero Adjustment
Pin
9 Bending Sleeve 13 Bending Plates
2 Electricity Board Cap 6 Stirrup Pin 10 Retainer 14 Bending Flange
3
Switch Adjustment
Pin
7 Straight Pin 11
Adjustment
spanner
15 Control Panel
4 Sensor Pin 8 Bending Pin 12 Machine Table 16 Foot Pedal
17 Plate
2. MACHINE ASSEMBLY
•
Machine should be leveled on a solid ground. Figure 2
•
Electricity connection of the machine should be made by competent technicians.
Explanation
Electricity Connection
For main electricity connection plug should be connected to supply line with a 5x4 mm²
isolated cable and then plugged into power outlet.
Grounding connection should be made for safety. Machine shouldn't be operated without
making grounding connection.
Connection of grounding line
The following procedures should be followed for this system.
Connect one end of the grounding to a copper wire (minimum 16 mm²) as it will enable
electrical conductivity. The other end should be either connected with a pipe that has a conductivity
capacity immerged into the ground (preferably into a humid ground) or the copper plate should be
buried into the ground as much as deep.
Figure 2: Leveling the machine on a solid ground