GMS B36, Руководство по эксплуатации и техническому обслуживанию

Страница: 11 / 29

B36
10
Figure 6: Wrong placement of the irons on the machine
Figure 7: Wrong positioning of the person making bend
7. PROHIBITED USAGE ON THE MACHINE
➢
When bending no one must stand in front of the machine and any one standing must be taken away.
(Figure 7)
➢
While the machine is running no any other construction material such as adze, hammer, meter,
caliper etc. should be put between the bending apparatus other than the material that will be bent.
➢
Machine mustn't be run when it is wet.
➢
No any bending must be made other than the measurements, dimensions and units stated on the
capacity plate
(Figure 1-16) .
➢
During the multi bending number of irons stated on the capacity plate should be aligned one on top
of the other and should be leaned to the retainer or bending rollers. No any other bending should be
made other than this.
(Figure 6c-6d)
€
Machine mustn't be run when the electricity Board Cap (Figure 1-2) is open.
€
Electrical settings made in the factory shouldn't be changed.
€
Machine shouldn't be operated without making grounding connection.
➢
Machine shouldn't be operated when the housing covers are dismantled.
➢
Machine should be operated by instructed workers.
➢
Machine never should be run unlubricated.
➢
Warning plates attached on the machine mustn't be removed.
(6d)