GMP 90000, Эксплуатация и обслуживание

Страница: 18 / 36

Page 18 General Machine Products (KT), LLC
7.7.5 WHAT TO DO IF MACHINE LOSES POWER
If the Hurricane loses electrical power for any reason the machine will retain the distance installed up to
that point, all other data (i.e. speed, pushing force, GPS etc.) will be lost. To retain the distance, you need
to the resume job. Do this by following the steps below:
1. The first to find out why the power has been lost, the most common reasons for this are:
a. Generator ran out of gas.
b. Electrical connectors no longer connected, this would include the generator to power supply
and power supply to machine connectors.
c. Damage to a lead and/or connector
2. Once the reason for power loss is found this needs to be rectified.
3. Now that the machine has power again you should see the main screen. To resume the job at the dis-
tance where power was lost press “ File Storage ”, “ Manage storage ” and finally “ RESUME ”.
4. The remote screen should now be on the pre - installation screen with the distance being the distance
when power failed.
5. Now proceed using sections 7.71 to 7.7.4.
Note: Do not open the airbox unless the air is dissipated beforehand, failure to do
so will likely result in injury
.
7.8 OTHER REMOTE FUNCTIONS
7.8.1 GPS LOCATION, TEMPERATURE AND HUMIDITY
The Hurricane machine is fitted with a GPS sensor along with a temperature and humidity sensor. These
sensors allow the altitude, longitude, latitude, temperature and humidity to be recorded, this will be saved
to the job data which can be downloaded. Information how to view this information can be seen in section
7.9.
7.8.2 SETTING THE DATE AND TIME
The date should be correctly set when the machine is delivered, the time should also be correct, but this
may dependant on time zone and daylight savings adjustments.
If the date or time needs correcting go to the main screen and press “ Settings ”, “ Set Date/Time ”
The date will be the date which the machine thinks it is but in the year 0020. For example, if the machine
thinks it is April 3
rd
2020 the date will read 04/03/0020, when date format is set to MM/DD/YYYY.
You can increase or decrease the day value, press next. This is then repeated for the month and year.
Once next is selected for the year you will be taken down to the time where you will do the above for the
hour, minute and seconds.
If the data is correct you can now save the changes. After this you will be taken back to the settings
screen.
7.8.3 CHANGING UNITS OF MEASURE
You can change the date layout and toggle between metric and imperial for the live data and odometer
units.
To do this from the main screen and press “ Settings ” then “ Units of Measure ” then follow the screen as re-
quired.
7.8.4 CHANGING THE LANGUAGE
The remote can be displayed in English, German, French, Spanish, Italian and Portuguese. To do this from
the main screen press “ Settings ” the “ Language ” and the scroll through and select the language required.