GMLR RECEPTION
TOOLS REQUIRED FOR ASSEMBLY
Cordless drill w/magnetic philips bit, tape measure, caulk gun
w/ construction adhesive, level.
BEFORE ASSEMBLING THE WORKBENCH
Read through the assembly instructions to familiarize yourself
with the order in which the parts are assembled.
S
TEP 1
S
TEP 2
Position the cabinet behind the desk “wall”. Inset the
cabinet 1” so that its not flush with the side of the wall.
Remove the drawers from the cabinet to access the back
side of the cabinets interior. The cabinet can be attached
to the wall using (4) #10 x 5/8” spax wood screws.
#10 x 5/8”
SPAX Wood Screw
Figure 1
Locate a flat & clean surface to work on. You may
want to lay down a blanket to avoid scratching the tops.
Lay the tops down, bottom side up. Connect the two
halves of your tops using the provided Draw Bolts.
Insert the Draw Bolts in the routered slots as shown
in Figure 1.
Make sure the 2 tops are even on the
finished top side before you fully
tighten the bolts.
Fully tighten all draw bolts.
