Page 6
Crathco® Beverage Dispensers
REMOVE BOWL AND
BOWL GASKET
Twist bowl back and forth
while lifting up. Bowl gasket
will be around bottom of
bowl.
STANDARD & MINI UNITS:
REMOVE VALVE AND HANDLE
Lift valve. Handle drops into
operator’s other hand.
REMOVE IMPELLER
AND BEARING
SLEEVE
Remove impeller and
bearing sleeve by
lifting them straight
up.
NOTE: Check
impeller and
bearing sleeves
for wear.
See page 8.
REMOVE LOCKDOWN WASHER(S)
THOROUGHLY CLEAN ALL PARTS IN WARM WATER
USING A MILD NON-ABRASIVE DETERGENT AND
RINSE THOROUGHLY.
CAUTION: ABRASIVES WILL SCRATCH PLASTIC PARTS.
WASH BOWL LIDS IN COOL OR LUKEWARM WATER TO
AVOID LEAKS DUE TO SEALED SURFACE BEING
DAMAGED.
NOTE: THE DISPENSER MUST NOT BE CLEANED WITH
A WATER JET.
SANITIZE
Immerse parts in sanitizing solution for 1-2 minutes.
Remove parts from sanitizing solution and drain.
DO NOT RINSE. Place parts on a clean surface to air dry.
Wipe the machine, condensate tray and cooling plate
depression with a cloth wetted with sanitizer solution.
IMPORTANT:
Never pour dry powder, crystals, or concentrate
into a dry bowl. Premixing beverage in separate container is
recommended. If mixing in bowl, always add water first.
2
5
6
DISASSEMBLY
DRAIN ALL BEVERAGE FROM BOWLS
A. Remove bowl lid(s) and drip tray(s)
B. Drain through valve then
C. Tip unit forward, gently press spray
tube back a short distance to lift the
edge of the pump cover to allow
remaining beverage in well to be
drained through valve.
1
7
Bearing
Sleeve
Impeller
3
Standard Unit: Twist lockdown
washer counterclockwise, slide
to release keyway. Then lift out.
Mini Unit: Slide to release
keyway, then lift out.
4
REMOVE PUMP COVER
Remove pump cover by
lifting up on spray tube.
