Page 4
Crathco® Beverage Dispensers
place BeaRinG sleeVe On
GUiDe pin
note flat sides on outside of
guide pin and on inside of
bearing sleeve.
line flat sides up until
bearing sleeve slides
down over guide pin and
rests on the cooling plate.
place pUMp cOVeR OVeR GUiDe pin
place the pump cover over the guide
pin with the spray tube toward the front.
note that the tab on the front of the pump
cover fits between the 2 locator buttons
or ridges on the bowl. Mini units -
bent part of spray tube faces front of bowl.
nOTe: Use agitator cover in place of
pump cover and spray tube for fresh
juice, drinks that foam (iced tea or dairy products), or heavy
viscous drinks.
place iMpelleR OVeR
BeaRinG sleeVe.
put impeller over bearing
sleeve with fin side up.
insTall lOcKDOWn WasHeR OR claMps
standard Units:
• place lockdown washer over guide
pin.
• push lockdown washer down and
into locking keyway.
• Turn lockdown washer
clockwise to lock into
place.
Mini Units:
• place lockdown washer
over guide pin.
• push lockdown washer
down and into locking
keyway.
• slide into locked
position.
place BOWl GasKeT On BOWl
Turn bowl upside down and
place bowl gasket over the neck
of the bowl. Moisten gasket
with water or a thin film of
lubricant.
pUT BOWl On Base
place the neck of the bowl over center of the cooling
plate and with a back and forth downward motion, push
bowl down into place.
asseMBle ValVe
anD HanDle
place handle (c) in the
two V-cuts in the front of
the handle bracket (B) and
push handle back.
From inside bowl, lower
the valve (a) through the
outlet hole, and through
the hole in the handle.
Release handle.
Replace DRip pan(s)
place cover/grid on drip pan.
place top edge of drip pan up
under lip on front panel.
lower each drip pan so that the
tab goes down into the tab slot
and locks pan in place.
1. HOLD HANDLE IN “V”
NOTCHES & LIFT REAR
OF HANDLE UP.
HANDLE
O-RING
VALVE
2
3
4
1
5
6
7
LOCKDOWN
WASHER
LOCKING KEYWAY
3/8” TAB
“FRONT” OF
DISPENSER
(TOWARD VALVE AT
FRONT OF BOWL)
HEAD OF GUIDE PIN
CROSS RIBS
PUMP COVER
Assembly
8
BASEPLATE
TAB
SLOTS
FRONT PANEL LIP
2. FROM INSIDE THE
BOWL, LOWER THE
VALVE THROUGH
OUTLET HOLE, AND
THROUGH HOLE IN
THE HANDLE.
Bearing Sleeve
Impeller
3. RELEASE HANDLE
