12
8. When there is approximately 150mm of line left, lock one
of the lines into one of the line location notches in the
spool head and the other into the opposing notch.
9. With the spring fitted onto the shaft of the spool holder
insert the spool back into the holder. As you insert
the spool, thread the lines through the eyelets and pull
firmly to disengage from the notch in the spool.
Note.
When inserting the spool into the housing, the spool
may need to be rotated slightly so as to locate into the
housing. Before the spool is fully inserted into the housing,
ensure the lines are free of the notches.
10. Once the spool is fully inserted and the lines are
fully through the eyelets, pull firmly on each line to
disengage the lines from the spool notches. Ensure the
lines are fully clear of the spool notches and the line is
passing through the eyelets directly to the spool.
11. To install the spool, line and housing, refer to ‘Fitting the
spool’ section of this manual.
Note.
On start up test the operation of the bump feed to
ensure the line feeds correctly.
CAUTION.
After changing the line spool, run the petrol line
trimmer under no load for at least a minute to make sure
that the line and the tool are both operating correctly. Use
only the line spool as recommended by the manufacturer.
WARNING.
Never use steel threads and/or three teeth
blade other than those provided by the manufacturer.
Always use tools in perfect condition, free of damage.
WARNING.
In high-speed rotation, parts could be projected
at very high speed and could involve serious injury and
damages to persons and property.
Maintenance
Air filter
Accumulated dust in the air filter will reduce engine
efficiency. Increase fuel consumption and allow abrasive
particles to pass into the engine. Remove the air filter as
often as necessary to maintain a clean condition.
•
Remove filter cover (12) by
pressing in the sides and
lifting it off.
•
Light surface dust can
readily be removed by
tapping the filter.
•
Heavy deposits should
be washed out in suitable
detergent.
•
Squeeze out the remaining water an allow the filter
to completely dry.
•
Add a drop of thin oil to the filter and replace it.
Fuel Filter
•
Fuel tank (7) is fitted with a filter.
•
Filter is situated at the free end of fuel pipe and can be
picked out through fuel port with a piece of hooked wire
or the like.
•
Check the fuel filter periodically. Do not allow dust to
enter the fuel tank. Clogged filter will cause difficulty when
starting engine or abnormalities in engine performance.
•
When the filter is dirty, replace the filter.
•
When the inside of the fuel tank is dirty, it can be cleaned
by rinsing the tank out with petrol.
Содержание LTP25SS
Страница 15: ...15...
