NOTE.
If you notice some flashing in the ventilation
shots, this is not a cause for alarm. It is normal and does
not affect the operation of the tool.
There is also a slight burning smell. This comes from the
electric brake and is not a cause for alarm either.
Shaping
1. Trim a hedge so that it is
wider at the bottom than
the top.
2. This improves light
penetration and promotes
healthy growth.
3. Narrow the hedge
approximately 100 mm for
every metre in height.
4. A bush can be round or
column shaped.
Cutting
1. Assume a secure position,
using two hands to
hold the trimmer and
switch on.
2. Trim both sides of the
hedge, starting at the
bottom. This prevents
cuttings falling into the
area yet to be cut.
3. Pass the blade lightly
through the surface of
the hedge. Do not
attempt to cut too deep.
4. Trim the top of the
hedge.
5. For older hedges that
require cutting back substantially, use pruning shears
to cut the thicker branches and then finish the job with
the hedge trimmer.
WARNING.
Do not let the blade come into contact with
fencing wire or any other object that could damage it.
Pruning
Your hedge trimmer is versatile. It can also be used for
trimming back new growth from small shrubs onto the
driveway or into the garden.
Lubrication
WARNING.
Switch off and remove the battery before
carrying out any maintenance on the tool.
1. After each use, clean the blades and lightly lubricate
with general purpose oil or spray lubricant.
General inspection
1. Regularly check that all the fixing screws are tight.
They may vibrate loose over time.
Maintenance
1. Store the tool, instruction manual and accessories in a
secure, dry place. In this way you will always have all
the information and parts ready to hand.
2. Keep the tool’s air vents unclogged and clean at all
times.
3. Remove dust and dirt regularly. Cleaning is best done
with compressed air or a rag.
4. Never use caustic agents to clean plastic parts.
CAUTION.
Do not use cleaning agents to clean the plastic
parts of the tool. A mild detergent on a damp cloth is
recommended. Water must never come into contact with
the tool.
8
