7-22
(17) = Check complete exhaust system and cab areas
near the exhaust system for broken, damaged, missing or
out
-
of
-
position parts. Also inspect for open seams,
holes, loose connections or other conditions which could
let exhaust fumes seep into the driver compartment.
Needed repairs should be made at once. To help
maintain system integrity, replace exhaust pipes
whenever a new muffler is put on.
(18) = Check all engine drive belts for cracks, fraying
and wear. Replace as needed.
(20) = With the engine off and below normal operating
temperature, check to see that the thermostatically
controlled engine cooling fan can be rotated by hand on
viscous
-
operated drives. Replace as needed.
(21) = Check shields and underhood insulation for
damage or looseness. Adjust or replace as needed.
(22) = Lubricate caliper housing, caliper support spring
and caliper support key.
(23) = Wheel bearing service:
D Grease type
--
Clean, inspect and lubricate with the
proper wheel bearing grease at designated intervals
or when hubs are removed. See “Recommended
Fluids and Lubricants” in the Index.
D Oil
-
filled type
--
Some wheel bearings are lubricated
by rear axle lubricant. When you have oil
-
filled
hubs, use lubricant identical to that used in your rear
axle. Lubricant change intervals are the same for
front and rear axles. However, you must maintain oil
level at the OIL LEVEL mark between change
intervals. See “Recommended Fluids and
Lubricants” in the Index.
(24) = Check the air intake system installation to see
that gaskets are seated properly and all hose
connections, fasteners and other components are tight.
For gasoline engines, also check to be sure the air
cleaner housing is properly seated, that the cover fits
tightly and that the wing nut is tight. Tighten
connections and fasteners or replace parts as required.
(26) = Evaporative Control System Service
(if equipped): Check all fuel and vapor lines and hoses
for proper connections and any damage (or every
24 months, whichever occurs first). Replace parts
as needed.
(27) = Replace air cleaner filter (or every 24 months,
whichever occurs first). Replace filter more often if
driving in dusty conditions. Ask your dealer for the
proper replacement intervals for your driving conditions.
Содержание C-Series 2001
