GMC 2008 Yukon XL Denali, Руководство пользователя, Страница: 351 / 502

A. Engine Air Cleaner/Filter. See Engine Air
Cleaner/Filter on page 5-17.
B. Air Filter Restriction Indicator (If Equipped).
See Engine Air Cleaner/Filter on page 5-17.
C. Coolant Surge Tank and Pressure Cap. See Cooling
System on page 5-29 and Coolant Surge Tank
Pressure Cap on page 5-26.
D. Remote Positive (+) Terminal. See Jump Starting
on page 5-40.
E. Battery. See Battery on page 5-39.
F. Engine Oil Fill Cap. See “When to Add Engine Oil”
under Engine Oil on page 5-13.
G. Automatic Transmission Dipstick (Out of View).
See “Checking the Fluid Level” under Automatic
Transmission Fluid on page 5-20.
H. Remote Negative (
−
) Terminal (GND) (Out of View).
See Jump Starting on page 5-40.
I. Engine Oil Dipstick (Out of View). See “Checking
Engine Oil” under Engine Oil on page 5-13.
J. Engine Cooling Fan (Out of View). See Cooling
System on page 5-29.
K. Power Steering Fluid Reservoir (Out of View).
See Power Steering Fluid on page 5-34.
L. Brake Master Cylinder Reservoir. See “Brake Fluid”
under Brakes on page 5-36.
M. Underhood Fuse Block. See Underhood Fuse Block
on page 5-111.
N. Windshield Washer Fluid Reservoir. See “Adding
Washer Fluid” under Windshield Washer Fluid
on page 5-35.
Engine Oil
Checking Engine Oil
It is a good idea to check the engine oil every time you
get fuel. In order to get an accurate reading, the oil
must be warm and the vehicle must be on level ground.
The engine oil dipstick handle is a yellow loop.
See Engine Compartment Overview on page 5-12 for
the location of the engine oil dipstick.
1. Turn off the engine and give the oil several minutes
to drain back into the oil pan. If you do not do this,
the oil dipstick might not show the actual level.
2. Pull out the dipstick and clean it with a paper towel
or cloth, then push it back in all the way. Remove it
again, keeping the tip down, and check the level.
5-13