For the VSP-F2L4 controller,You only can build an LED screen addresses diagram which controlled by
one controller port,for the SDV signal divider you only can set one signal divider port's addresses for one
time. Please remember to rebuild a simulator diagram when set an addresses for another port. Please select
correct controller port and signal divider port when you start the addresses setting. Otherwise, the display
addresses of the LED screen will no reaction.
12
5
Safety Summary
Read the following safety precautions carefully to avoid injury and prevent damage to this product or any
products connected to this product. To avoid potential hazards, use this product in accordance with regulations.
Only qualified personnel can perform service procedures.
1. avoid fire or personal injury.
use the appropriate power line. Please only use the dedicated power cord for this product , which acquire
the international / regional certification.
Connect and Disconnect Properly. When add Connection and removal of all connection operation, make
sure no contact with the voltage source.
2. Make the product grounded.
The product is grounded through the grounding conductor of power line in order to avoid electric shock, the
grounding conductor must be connected to the earth well. Before the power input or power output of this product,
make sure it is correctly grounded.
3.comply with all terminal ratings.
To avoid fire or electric shock, observe all ratings and markings on the product, before make connections to
the product, read the manual for further ratings information. The voltage applied to any terminal and the power
requirements do not exceed the maximum rating of the terminal.
4 .Do not operate without covers. Do not open the housing or panel when using the product.
