Glunz & Jensen Plate Processor 150, Руководство по установке

Страница: 16 / 40

Lifting/Transporting
Lifting the Processor off the Pallet
The processor should be lifted off the pallet using two hand-powered pallet forks.
$ When lifting be careful not to damage the drain equipment on the right side of
the processor.
•
Mount the wooden planks (1) on both sides of the processor stand using the bolts
and nuts (2) supplied in the plastic bag.
•
Place the ramps (3) as illustrated.
•
Place the crate top (4) and side (5) on top of the wedges.
•
The processor can now be lifted from under the planks (1) using a pallet fork (6) on
each side and moved away from the pallet in the direction shown.
Transporting
The assembled processor can be transported either from the side by raising it from un-
der the wooden planks
(1) on both sides (using two hand-powered pallet forks), or
from the front by raising it from under two crossbars (2) (one of which is taken from the
crate lid) inserted underneath the bars (1) (using two hand-powered pallet forks or a
forklift truck with minimum 150 cm forks). For this purpose you need to adjust the ad-
justable feet
(3) to maximum height.
Installation Manual - Plate Processor 150 1049
2-8
Installation
Lifting/Transporting
T31660
2 3
1
2