GLP impression X5, Руководство пользователя

Страница: 20 / 80

www.glp.de
20
impresssion X5 User Manual
No signal
The No signal settings let you manage how the fixture behaves if no DMX signal is
present (if the fixture is being controlled by DMX but the DMX signal stops, or if you
apply power to the fixture when no DMX signal is present):
●
Blackout sets the fixture to black out whenever it is not receiving a DMX signal. This is
the default setting.
●
Hold sets the fixture to continue using the last DMX values it received.
●
Scene (Stand-alone) sets the fixture to play its stored stand-alone scene (see
Capture DMX Values below) when the fixture is not receiving a DMX signal. If no
stand-alone scene is stored in memory, the fixture will black out.
If the fixture is set to Scene (Stand-alone) and if a stand-alone scene has been
stored in its memory using the Capture DMX Values command, it will display its
stand-alone scene at all times when it is powered on but not receiving a DMX
signal. You can therefore use this setting if you want fixtures to automatically start
stand-alone operation when you apply power to them.
●
Capture DMX Values takes a snapshot of the DMX values that are currently being
received and stores them in the fixture’s memory as its captured scene. The fixture
will display this scene if it is set to Scene (Stand-alone) (see above) and is not
receiving a DMX signal.
Pan Invert
Reverses the direction of pan.
●
Off – In the normal setting, increasing the pan value turns the yoke clockwise (as
seen with the fixture standing on the ground).
●
On – In the inverted setting, increasing the pan value turns the yoke
counterclockwise (towards the grey safety eyelet).
Tilt Invert
Reverses the direction of tilt.
●
Off – In the normal setting, increasing the tilt value turns the head to the FRONT
(towards the black safety eyelet).
●
On – In the inverted setting, increasing the tilt value will turn the head to the BACK
(towards the grey safety eyelet).
Position feedback
Manages pan and tilt auto-correction.
●
Pan and tilt position feedback is normally enabled ( Position Feedback = On ).
●
If disabled ( Position Feedback = Off ), the fixture will not auto-correct pan and tilt
position.
If you need to return pan and tilt to their correct positions, you must perform a reset.