Glowworm EASICOM 3, Инструкция по установке и обслуживанию

Страница: 29 / 48

0020238431_03 EASICOM 3 Installation and maintenance instructions
29
D
C
B
2
3
A
5. Remove the screw (2) .
6. Push the clip upwards.
7. Remove the flue pipe (3) .
B
A
D
C
4
5
8. Remove the plugs from the gas valve assembly and
from the fan.
9. Remove the gas-air mixture unit .
10. Remove both burner seals from the burner hood.
11. Remove the burner
(4) .
12.7 Cleaning the heat exchanger
1. Check the heat exchanger for damage and dirt.
2. If required, clean and replace the heat exchanger.
3. Protect the open electronics box from spraying water.
1
4. Clean the ribs of the heat exchanger (1) with water.
◁
The water runs out via the condensate tray.
12.8 Checking the burner
▶
Check the surface of the burner for damage. If you see
any damage, replace the burner.
12.9 Checking the ignition electrode
1
2
3 4 5
1. Disconnect the connection (2) and the earth cable (1) .
2. Remove the fixing screws (3) .
3. Carefully remove the electrode from the combustion
chamber.
4. Check that the electrode ends (4) are undamaged.
5. Check the electrode distance.
–
Clearance for the ignition electrodes: 3.5 to 4.5 mm
6. Make sure that the seal (5) is free from damage.
▽
If necessary, replace the seal.