Glow-worm Energy7 25c -A, Инструкция по установке и обслуживанию, Страница: 42 / 64

13 Troubleshooting
42
Installation and maintenance instructions Energy
7
0020300875_01
13.6.6 Replacing the PCB
C
C
D
B
A
A
1. Open the electronics box.
2. Pull all of the plugs out from the PCB.
3. Undo the clips on the PCB.
4. Remove the PCB.
5. Install the new PCB in such a way that it clicks into the
groove at the bottom and into the clip at the top.
6. Plug in the PCB plugs.
7. Close the electronics box.
13.6.7 Replacing the PCB for the user interface
B
C
C
D
A
A
1. Open the electronics box.
2. Pull the plug out of the PCB.
3. Undo the clips on the PCB.
4. Remove the PCB.
5. Install the new PCB in such a way that it clicks into the
groove at the bottom and into the clip at the top.
6. Plug in the PCB plug.
7. Close the electronics box.
13.6.8 Replacing the expansion relief valve
1
2
1. Remove the clip (2) .
2. Remove the expansion relief valve.
3. Fit the new expansion relief valve with a new O-ring.
4. Reattach the clip (2) .
13.6.9 Replacing the volume flow sensor
1
B
A
1. Pull out the plug.
2. Remove the volume flow sensor (1) .
3. Install the new volume flow sensor.
4. Plug in the plug.
13.6.10 Replace the pressure sensor
1
2
1. Pull out the plug.
2. Remove the clip (1) .
3. Remove the pressure sensor (2) .
4. Install the new pressure sensor.
5. Reattach the clip (1) .