55069F – Reversing camera with parking sensor - 12V
The key to safe reversing! Two in one device, reversing camera and sensor in one unit. It is
easy to install thanks to the mounting bracket and is compatible with most cars. Part of the set
is a speaker that makes a sharp beeping sound when an object comes close to the ultrasonic
sensor.
Easy to install
Compatible with all cars
Wide viewing angle
Built-in 1pc ultrasonic sensor
1 pc beeping speaker
RCA signal cable connecting to the display (the display is not part of the set!)
Power source:
12V
Camera viewing angle: 170°
Resolution:
720 x 480 px
Range:
0 - 2 m
Set includes:
1 pc reversing camera and sensor unit
1 pc beeping speaker
1 pc set of cables
Size:
68 x 30 x 30 mm
Signal cable length:
6 m
Color:
Black
Material:
Plastic
Protection:
IP67
Warnings:
-
The surface of the sensor must be kept clean!
-
When reversing, always check the environment, look around and use the rear-view mirrors!
-
Reverse at low speed to react to unexpected situations!
-
Have the appliance installed by a specialist!
-
Disconnect the cable from the battery (+) terminal before installation.
-
Wiring:
1.
Connect the wires with the red connector to the reversing lamp connector and provide
adequate insulation.
2.
Connect the black cable to a ground cable or a point on the car body.
3.
Connect the beeper speaker to the appropriate connector on the camera.
4.
Use the yellow RCA cable to transmit the video signal to the display. The connection of the
red wire is optional, this wire is used to switch the signal source of the display. In this case,
also connect itt o the reversing lamp connector.
