GlobalTime NTP Products
13
1.
Network Information
2.
NTP Configuration
3.
SNMP Setting
4.
Heart Beat check
5.
NTP status
6.
GPS status
7.
System function
8.
Change the password
9.
Q. Exit
3.4.2
Change network setting
When you press "1 ENTER" in the main configuration interface, initially it will ask whether to
use DHCP protocol to assign IP address. If you would like to use DHCP protocol to assign IP
address, then select "Y". Otherwise, select "N". GTT-100 support IP address through DHCP,
but it always need a static IP address because the server needs to supply the network timing
service to other devices. As a result, in DHCP network system, the recommended
configuration is to assign a static IP address from the IP Pool of DHCP server
to GTT-100.
Other devices can use the static IP to access GTT-100.
When it asks whether to use DHCP, If you select "N", it will prompt to enter the server IP
address, netmask and gateway IP address. Finally it will prompt whether to modify the
network configuration in accordance with settings entered, then select "Y" and it will change
the equipment configuration. This configuration can not take effect until rebooting the server.
So we need to restart the server. We can modify the network configuration for many times
before restarting the equipment, but only the last one can take effect. The configuration
interface is shown in Figure 3-4.
Figure 3-4
The network parameters configuration interface
