D3plug User Guide
–page
6
/
14
E. Basic procedures for debugging
1. Connect cablesas illustrated in section C.
2. Run terminal program on Linux PC like Hyper-terminal or putty
3. Type in #minicom
4. Power on the D3Plug.
5. Normally, you will see messages on screen as below:
You can press any key to stop auto-boot when you see the bootdelay timer is counting down.
After entering the uboot prompt, you can also change the uboot environment variables such as bootdelay time,
Ipaddr,serverip and so on.
If no key has been pressed to interrupt the uboot, it will continue running to the login screen where it urges you to
input the login name and password, here is the default login information.
Login :
root
Password:
nosoup4u
