Globalsat GH-209, Руководство пользователя

Страница: 11 / 22

8. About
8.1 VERSION
8.1.1 FIRMWARE
8.1.1.1 Here shows you the main firmware version. Ex. F-0GH-2X-1501152, 150115 is the
date of FW released which is 2015 Jan 15
th
.
8.1.2 BLE FW
8.1.2.1 Here shows you the BLE firmware version. Ex. F-BLE-29-1503271, 150327 is the date
of FW released which is 2015 Mar 27
th
.
NOTE: To check firmware information, please refer to Get More Information.
8.2 RESET
8.2.1 Allow you to reset the watch back to factory setting.
8.2.2 Default value is DON’T!! in case incidentally trigger reset.
8.2.3 Even OK! Was pushed, double confirmation will reserve a second chance.
Pair BLE Heart Rate Monitor (HRM) chest belt
NOTE: if you don’t have a BLE Heart Rate Monitor, you can skip this section.
Wear the Bluetooth Low Energy (BLE) heart rate monitor directly on your skin, just below your
breastplate. It should be snug enough to stay in place during your run.
1 Wrap the strap around your chest, and connect the strap hook to the loop.
2 Connect the heart rate monitor module to the strap.
3 Wet the electrodes (Location A and B) on the back of the strap
to create a strong connection between your chest and the
transmitter.
NOTE: Some heart rate monitors have a contact patch.
Wet the contact patch.
4 Bring the watch in front of you and
ensure the transmission range within
(2m) of the heart rate monitor.
TIP: If the heart rate data is erratic or does not appear, you may have to
tighten the strap on your chest or warm up for 5 to 10 min.
NOTE: Move away (20m) from other sensors while GH-209 is trying to
pair with your heart rate monitor
5 After you put on the heart rate monitor, it is on standby and ready to send
data.
6 Go to your watch, enter SETTINGS > PAIR > HR SENSOR > ON , start paring
for 60 sec. Please follow the display instruction.
10