CHAPTER 2 – INSTALLING A NEW CABINET
Deluxe Cabinet Installation
Begin by removing the monitor console, driving console, and driving seat from the packaging. It is suggested
that you do the final assembly at the location were the game will be played. This way each separate console
and seat will have plenty of clearance to pass through normal size doors in your location.
1. Secure the bottom bracket of the front monitor bezel to the monitor console with (3x) ¼ -20 x 1" hex bolts
and washers. See below.
SWING TO
OPEN/CLOSE
Front Monitor Bezel
(3x) 1/4-20 x 1" Hex Bolts and Washers
Monitor
Console
Bottom
Bracket
Figure 7
– Securing the Front Monitor Bezel
2. Locate the console rails inside the monitor console. Use (8x) ¼-20 x 2" Torx-security bolts, (8x) ¼ fender
washers, and (8x) ¼" lock washers to secure the rails to the monitor console. Do not tighten the bolts all
the way down until the last step in these instructions. See the figure below.
Figure 8
– Attaching the Console Rails, and Mating the Consoles
3. Slide the driving console onto the rails. Leave enough room between the two consoles so that you can get
your hand in and connect the wiring harnesses between the 2 consoles. See the figure above.
10
GLOBAL
VR
040-1201-01 Rev. C 5/28/2004
