Before you begin: Check components to verify all are included. Assembly requires two people and must be performed on a flat and
even surface. Do not overtighten hardware as damage can occur.
As of 10/2019
Page 1 of 2
CONTENTS
Ref. Qty.
Description
1
2
A-Frame
Bases
2
3
Table Top
Slats
3
2
Seat
Slats
Ref. Qty.
Description
4
2
Angle
Supports
5
1
Horrizontal
Support
H1
1
Hardware
Pack*
72” A-Frame Picnic Table
Assembly Instructions
Assembly Instructions
Customer Service
US: 1-800-645-2986
Model #s: B264184, B264186, B264228
(23) 3 1/2" Hex Lag Screws
(23) Flat Washers
(6) 3" Deck Screws
*Contains:
Step 1
Stand A-frame bases upright and parallel to each other, the horizontal
supports should face away from the center of the table. Place a slat on
the top edge of the horizontal 3 x 6 of the A-Frame base supporting the
seat. The pre-drilled holes should align more or less with the center
line of the 3 x 6 support. Ensure the bases are square and plumb. Use
the pre-drilled holes in the seat slat as a guide, drill starter holes in the
3 x 6 and attach using the 3 1/2” hex lag screws and flat washers.
Repeat on the other side.
Step 2
Place the table top slats spaced evenly on the A-Frames
top supports, the pre-drilled holes should align more or less on
the center line of each 3 x 4 cross support. Attach using the
3 1/2” hex lag screws and flat washers.
