5.7 REMOVAL OF THE CUTTING DECK
Removing the cutting deck facilitates all the over-
haul and replacement of hubs, bearings and blade
shafts.
With some practice and experience it is possible
to do this work with the deck still in position.
Remove the collector channel [see 5.3]
Free the blade belt
(1)
from the clutch pulley
(2)
and
set the cutting height adjustment lever to position
“1”.
Unscrew the nut
(3)
and disconnect the steering rod
(4)
to allow the passage of the belt.
Uncouple the two front flexible split pins
(5)
and the
three flexible split pins
(6)
of the lifting tie-bars.
Having checked that there are no obstacles, the
plate can be removed, slightly rotating it anticlock-
wise, so that all the pins come out of their housings.
For reassembly perform the operations described
above in
reverse, making sure that the blade control
belt
(1)
remains above the steering rod
(4)
.
IMPORTANT –
It is always advisable to replace the
nut
(3)
whenever it is dismantled.
When assembly is completed …
Reattach the collector channel [see 5.3].
Check the alignment of the cutting deck [see
4.
Tightening torque
3
Steering rod fixing nut ...................... 18 ÷ 20 Nm
6
4/2007
5
3
4
2
1
© by GLOBAL GARDEN PRODUCTS
N...92
WORKSHOP MANUAL
REMOVAL OF THE CUTTING DECK
5.7
0
1 / 1
page
from
2007
to
••••
<= ...BACK... <=
Содержание N 92 Hydro Series
Страница 1: ......
