16
www.dimplex.com
Operating Instructions
1.
Switch on the circuit breaker. The heater will begin in
Standby mode. When the unit is in Standby, the lowest
heat temperature setting LED will be flashing to indicate
the unit is in Standby.
2.
Point the remote control directly to the receiver, press
‘LOW’
,
‘MED’
,
‘HIGH’
to set your desired temperature
setting. The red LEDs on the display panel will illuminate
to indicate the power level. One red LED indicates that
the unit is set to Low, two red LEDs indicate that the unit
is set to Medium, and three LEDs indicate that the unit is
set to High.
!
NOTE:
It is recommended that the distance between the
heater and the remote be less than 3 m (9.8 ft.), and the
remote control must be pointed directly to the receiver on
the front panel during the operation.
!
NOTE:
When the 'ON' button is used to turn on the
heater, it will start up on the high temperature setting.
3.
To set the heater to standby mode point the remote control
directly at the receiver and press ‘Standby’. At this time
the lowest heat temperature setting LED will be flashing to
indicate the unit is in Standby mode.
!
NOTE:
T
here is a built in safety feature that will
automatically trigger the heater to go into standby mode
after eight hours of continuous operation. At this time the
lowest heat temperature setting LED will be flashing to
indicate that the unit is in Standby.
WARNING:
The heater must be properly installed before it is used. Slight crackles may be heard during the heating or cooling
period. This is a normal part of the operation of the heater.
on
off
Power
Low
Med
High
on
Standby
Timer
1hr
2hr
Power/On
1
2
4
6
Power
Timer
（
Hours)
1
2
4
6
Power Timer(Hours)
Power
Timer
L
M
H 1hr 2hr
Power
Timer
L
M
H 1hr 2hr
TIMER FUNCTION
Your Dimplex infrared heater comes with a programmable timer that will automatically place the heater in Standby mode after
1, 2, or 3 hours of operation. Once in Standby mode a single red LED will be flashing.
Power
Timer
L
M
H 1hr 2hr
Power
Timer
L
M
H 1hr 2hr
Power
Timer
L
M
H 1hr 2hr
1. To operate the timer point the remote control directly to
the receiver. To set the timer for 1 hour, point the remote
control directly to the receiver and press ‘1 hr.’ A single
green LED light will illuminate on the unit's display panel
under ‘1 hr.’ to indicate that the timer is active.
2. To set the timer for 2 hours of operation point the remote
control directly to the receiver and press ‘2 hr.’ A single
green LED light will illuminate on the unit's display panel
under ‘2 hr.’ to indicate that the timer is active.
3. To set the timer for 3 hours of operation point the remote
control directly to the receiver and press ‘1 hr.’ and ‘2 hr.’
Both green LED lights will illuminate on the unit's display
panel to indicate that the timer is active.
