GLD Products STORMSTRIKE SPACE SAVING BILLIARD TABLE, Руководство по замене запасных частей

Страница: 7 / 21

GLD Products Space Saving Billiard Table
Item 64-6033
7 1-800-225-7593
www.gldproducts.com
STEPS TO ATTACH THE LEGS
1. Place the pre-assembled table assembly (#1) top down on a ! at work area.
Note: If the work surface is rough, use the cardboard packaging material over the rough
surface. This will help prevent scratches.
2. Locate the end of the table that has two holes in the apron. Position an "L" shaped leg
(#2) so that it points away from the center of the table. The two legs are not the same.
Look at both sides of a leg. One side has a plastic disk. That plastic disk must be on the
outside of each leg to allow the legs to lock in position. Position the locking disk on the
leg to line up and lock with the disk mounted on the side skirt.
3. Attach the two "L" shaped legs (#2) using wing bolts (#12)
4. Hold a leg (#2) in postion with the locking disks seated together. Screw the wing bolt
(#12) through the side skirt and into the leg (#2). When the threads of the wing bolt
(#12) begin to show on the inside, screw one of the nuts (#13) onto the threads.
Note: Only one side of the nut will thread onto the wing bolts. The side with the round dome
has a plastic insert that will "lock" the nut in position. Thread the nut onto the wing
bolt putting the ! at side $ rst.
5. Use the wrench (#6) to hold the nut (#13) and screw in the wing bolt. When the wing
bolt (#12) is completely screwed in, the nut (#13) will need to be adjusted.
Note: When the position of the nut on the threads of the wing bolt is correct, the plastic
disks on the leg and table skirt will disengage enough to allow the leg to swing
up and down. If the nut is backed away too far, the leg will be excessively loose
(wobbly) during the folding process.
6. Adjust the position of the nut (#13) so the wing bolt (#12) is screwed in completely and
the two plastic disks are engaged. Hold the wing bolt (#12) and put the wrench (#6) on
the nut (#13). Move the nut until there is a gap of 3/8" between the nut (#13) and the leg
(#2). Test the movement of the leg (hold the leg with one hand) by unscrewing the wing
bolt (#12) until the nut (#13) contacts the inside of the leg. The leg should move up and
down easily. The plastic disks should pass over each other and the leg should not be
excessively loose (wobbly). Adjust the nut (#13) on the wing bolt (#12) as needed.
7. Repeat Steps 4, 5 and 6 on the second L-shaped leg (#2).